bottom plug
3 posts
• Page 1 of 1
bottom plug
Dear HR29 sailors,
does anyone know, where I can find the bottom plug in my HR29? Didn't notice that such a plug exists.
For information:
https://reginasailing.com/refitting-you ... tom_plugg/
Kind regards
Martin (SY Isabell)
does anyone know, where I can find the bottom plug in my HR29? Didn't notice that such a plug exists.
For information:
https://reginasailing.com/refitting-you ... tom_plugg/
Kind regards
Martin (SY Isabell)
Re: bottom plug
Hey Martin,
the bottom plug can be purchased from the Hallberg Rassy Parts shop either alone or as the complete bilge plug assembly:
https://shop.hallberg-rassy.com/contents/en-us/p65.html
https://shop.hallberg-rassy.com/contents/en-us/p66.html
I was also planning to check out our plug but found that it is covered by a thick layer of epoxy-primer on our boat. Do you know whether the solid or hollow plug was used on the HR29?
Cheers,
Nils
the bottom plug can be purchased from the Hallberg Rassy Parts shop either alone or as the complete bilge plug assembly:
https://shop.hallberg-rassy.com/contents/en-us/p65.html
https://shop.hallberg-rassy.com/contents/en-us/p66.html
I was also planning to check out our plug but found that it is covered by a thick layer of epoxy-primer on our boat. Do you know whether the solid or hollow plug was used on the HR29?
Cheers,
Nils
Re: bottom plug
Hello Nils,
thanks for reply, good to have the part-numbers. Unfortunately I do not know, whether we have the hollow ones or the solid ones. Until now, I didn't even know that we have bottom plugs. The only use is to rinse the bilge completely, standing on land, I thought they were not necessary on a small boat like ours. Think I'll ask HR support about that question.
When there is a thick layer epoxy, it seems to be safe and tight, I read about just color over the corroded hollow one.
Regards
Martin (SY Isabell)
thanks for reply, good to have the part-numbers. Unfortunately I do not know, whether we have the hollow ones or the solid ones. Until now, I didn't even know that we have bottom plugs. The only use is to rinse the bilge completely, standing on land, I thought they were not necessary on a small boat like ours. Think I'll ask HR support about that question.
When there is a thick layer epoxy, it seems to be safe and tight, I read about just color over the corroded hollow one.
Regards
Martin (SY Isabell)
3 posts
• Page 1 of 1
Return to Maintenance and refit
Who is online
Users browsing this forum: No registered users and 1 guest